Bosch Go 2 Mini Electrical Screwdriver Set Hand 3.6V Rechargeable Automatic Screwdriver Hand Drill Bosch Go2

Bosch Go 2 Mini Electrical Screwdriver Set Hand 3.6V Rechargeable Automatic Screwdriver Hand Drill Bosch Go2

Feature :
Minimum Effort. Maximum Efficiency

❀Easy to control - tools stops immediately after deactivation via electronic brake

❀Dual-activation mode – Simply push tool or press button to begin
❀Precise or Power – Mechanical clutch with 6 torque settings and maximum performance mode

❀Mechanical Clutch – Precise with 6 torque setting and maximum performance mode

Specifications :
Voltage : 3.6V
Battery (Ah) : 1.5H
Torque (Nm – Hard/Soft/Min) : 5/2.5/0.2
Speed (RPM) : 360
Electronic Brake : Yes
Smart Stop : Yes
Activation Mode : Push Start & Press Button
Mechanical Clutch Settings : 5 + Maximum Performance Mode
Charging Port : Micro USB
Tool Holder : ¼" Inter HEX

Package Includes :
1 x GO 2 Kit Smart Screwdriver
1 x Micro USB Cable
1 x Plastic Case
1 x Instruction Manual

Free Switchable
Dual boot design, meet different habits, easy to use and more practical

Home improvement / Repair is a good helper

1,Select drive gear /reverse gear 2, Choose the right torque

3, Thrust / press and hold scwich tostart up

31 in 1 screwdriver bit set

Original BOSCH 25 in 1 Bits Kit


FAQ :

1)How to start the tool?
- Select the direction from F/R switch and push the tool Or Press the button

2)Can this tool use as a manual screw driver?
- Yes, put the F/R switch to neutral position, then the tool can be used as manual screw driver

3)How much screws can be done per charge?
- Approx. 196pcs 3.5x35mm screwing into softwood,
- Approx. 200pcs 3x60mm machines screw into plastic.

4)Where is the charger for the tool?
- All SKU doesn't come with a charger. However you can use your phone USB adaptor to charge the tool with supplied micro-USB cable

5)When should I charge the tool?
- When the battery capacity is below 33%, the charge indicator LED will start to blink during activation. This indicate the tool should be charge.

6)How to know when the tool is fully charge?
- During charging process, the charge indicator LED will blinking continuously. After full charge, the LED will stop blinking and stay ON.

7)What's the charging time?
- 90min for 100%. 60min for 80%

8)Can I use the tool while charging?
- No, the tool won't work once start charging.

9)How is the performance of the tools?
- It is same powerful as previous generation, however is more precise with mechanical clutch now

10)How to select the right torque?
-The torque setting has 5 levels, which shows from small screw to big screw. The tool will start clutching once reach the desired torque. Turn to Max mode for full power.
Note: When set to Max mode, tool won't stop. it will stop only if reach the maximum torque of the tool.